This Switch Fabric board supports ethernet connectivity between the three DSCXL processors. Unlikely, but perhaps the Switch Fabric board has failed (the top board in the cPCI shelf). If you combine points (1) and (2), it sounds as if the problem may be the HDCF board, or the hard drive. (3) Did you remember to install the SiM card on your new ADP? That's OK - the SWUs do not need to access the hard drive unless someone attempts to invoke certain features e.g. Without the ADP, the SWUs cannot access the hard drive. (2) You say that the ADP originally failed, but the SWUs continued to function. However, since it cycles, it apparently cannot find a load device. (1) When your ADP reaches a "6", it is attempting to find a load device (Hard Disk or CF card), so that's telling me that the ADP board is probably OK. Difficult to troubleshoot without being there, BUT:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |